Mitsubishi Triton MN 203p - Page 8

POSITION THE SPORTS BAR AND CORNER PIECES ON THE VEHICLE. ATTACH THE LEGS OF THE SPORTS BAR USING THE
RETAINED HARDWARE. NOTE: PUSH DOWN ON THE SPORTS BAR AND LIGHTLY TIGHTEN HARDWARE.
TC0169eMITSUBISHI TRITON 3 PIECE TONNEAU COVER
29/10/10Page 8 of 13
FIG. 24
ISSUE05
NO POWER TOOLS
SIDE VIEW
SPORTS BAR HARDWARE
SPORTS BAR
2
3
FIG. 27
FIG. 26
CLEAN THE PREVIOUSLY NOTED AREAS ON TUB WITH ALCOHOL WIPE PROVIDED AND WIPE AWAY RESIDUE WITH A DRY CLEAN
CLOTH. POSITION CLEAR ANTI-RUB PADS AT THESE AREAS ON THE TUB.
FIG. 25
NOTE THE AREA WHERE CORNER PIECE CONTACTS THE VEHICLE TUB AS SHOWN.
MARK THE EDGES AS SHOWN WITH A PENCIL OR NON-PERMANENT MARKER. REPEAT PROCESS FOR THE OTHER SIDE.
REMOVE SPORTSBAR AND CORNER PIECES FROM TUB.
RE-POSITION THE SPORTS BAR AND CORNER PIECES ON THE VEHICLE. ATTACH THE LEGS OF THE SPORTS BAR USING THE
RETAINED HARDWARE. NOTE: PUSH DOWN ON THE SPORTS BAR BEFORE TIGHTENING HARDWARE.
NO POWER TOOLS
SIDE VIEW
SPORTS BAR HARDWARE
SPORTS BAR
2
3
MARK THESE 2 EDGES
ON THE TUB
28