MIVARDI | 7
When the bite alarm is paired with
the receiver, press the “+” and “-”
buttons for 2 seconds and the sound
will beep once, then press the “+”
button to select which LED on the
receiver is used for the shot. You will
then confirm your chosen colour by
moving the rotary wheel on the indi-
cator. Thanks to this, the receiver will
receive a signal and your selected
colour will be stored in the receiver.
After detected the signal of bite alarm,
the LED starts flash, the sounds beeps
synchronously with the bite alarm,
and then the LED will continue to flash
(when the wheel rotate backward) /
light (when the wheel rotate forward)
20 seconds after the last beep.
6. Erasing code
Press the “+” button and hold the “-”
button for 4 seconds until all LEDs
light up. When all the LEDs go out, all
transmitter pairings are cleared.
7. Working mode
Bite indication (front) running = The
LED of the receiver is blinking and the
sound beeps in synchronisation with
the bite alarm. The receiver continues
lighting for 20sec after the wheel
stops rotating.
Bite indication (backward) running
= The LED of the receiver is lighting
and the sound beeps in synchronisa-
tion with the bite alarm. The receiver
continues blinking for 20sec after the
wheel stops rotating.
8. Light function on the receiver
If we press the power button twice,
one white LED on the receiver
antenna lights up.
Turn the light off again by double-
-pressing the power button.
9. Anti -theft function
If the anti -theft alarm is started by
the bite alarm then the correct LED
flashes on the receiver, which is
intended for the given bite alarm +
the same beep sequences that are
selected for the given bite alarm are
also available on the receiver; when
the bite alarm stops beep, the LED in
the receiver flashes 20 seconds.
10. Low battery warning
The low battery warning starts when
the remaining battery capacity allows
last 8 -10 hours of working time of the
receiver (Low electric voltage value is
3.6 V, normal is 4.5 V),
If the battery on the receiver is low,
there will be one long beep (0.5 s) that
the receiver will emit every 20 minutes
+ all 6 coloured LEDs on the receiver
will light up for 5 seconds.
11. Bivvy Light
Activate bivvy light function = press “+”
button for 3 seconds. The receiver will
provide one beep and one blink of the
torch light.
Deactivate bivvy light function = press
“+” button for 3 seconds. The receiver
will provide two beeps and two blinks of
the torch light.
When the bite alarm is indicated the
torch LED will switch on for 25 seconds
and then it will switch off automatically.
If you turn on the torch light function,
the torch light will remain on. After the
torch light is turned off, the „bivvy light“
function will only be activated.
SAFETY INSTRUCTIONS
• Familiarise yourself with all functions and controls before using the alarm kit.
• Avoid dropping or possible impacts to the device.
• Do not turn on the device near the ears and eyes of animals and people.
• Never place batteries in ahot environment.
• Store the device out of the reach of children and animals.
• Recycle all packaging materials according to the regulations in your country.
• In the event of adevice malfunction, do not open it and contact your dealer.
• Always use quality and branded batteries. Do not mix new batteries with old ones, or different types
of batteries.
• Always dispose of batteries according to regulations.
• Do not throw non -functional batteries into fire.
• When not using the device for along time, we recommend removing the batteries.
To Next Page
Loading...