MIXER 70 - Machine Operation; Prerequisites for Use; Start and Stop Procedure; Mixing Process

User manual - MIXER 70 202303-648-ENGP10
4. USE OF THE MACHINE
4.1. PREREQUISITES
• The electric connection has to be 230 V - 16 A - 50 or 60 Hz with a 3 x 2,5 mm cable reel of 40m
maximum, completely unreeled.
• The mixer is equipped with a security grid (A). If the grid is open, the display (F) shows SEC and the
mixer will not start. Close the grid to activate the mixer.
START / STOP
• Once the machine has been connected, the machine is in the stop mode, the display (F) shows
OFF.
• One push of the ON/OFF button (1), the display (F) shows the set value of the speed in %, the
warning light (L1) lights up, the machine is ready.
• When the machine is working (warning light (L1) is on), one push of the button ON/OFF (1) will
switch the machine o󰀨. The display (F) will show OFF and the warning light (L1) will switch o󰀨.
MIXING
• One push of the button MIXING (2) will provoke the start-up of the mixing (alternate rotation) and
the warning light (L2) lights up.
• The button (4) and (5) allow you to increase or to reduce the speed of rotation.
WATER DOSAGE
• Set the wanted water quantity with the buttons (8) and (9). The display (G) will show the set value
in liters. Once you have set the water quantity, the display (G) will once again show the last injected
water quantity
• One push of the button DOSAGE (6) starts the dosing of the water, the warning light (L4) lights up
during the duration of the dosing and the display (G) increments the injected water quantity. Once
the set amount has been reached, the water dosage stops automatically and the warning light (L4)
switches o󰀨.
• During the automatic cycle, one push of the button DOSAGE will pause the dosing. Another push
will re-start the cycle.
• One push of the button +WATER provokes a water ow as long as the button is kept pressed. The
display (G) will add the water quantity to the one previously shown. This function is only possible
outside of the automatic water dosing seen above.
In case of a dysfunction of the machine, one 3 second push on the ON/OFF (1) will
allow you to verify that the power supply is over 210 V.