To Next PageTo Next Page
Need help?Do you have a question about the Mizu Drift MK2 and is the answer not in the manual?
General| Brand | Mizu |
|---|---|
| Model | Drift MK2 |
| Category | Bathroom Fixtures |
| Language | English |
Product must be installed by a qualified electrician per AS/NZS 3000 wiring rules.
Suitable for dry areas; not for baths, saunas, steam rooms or shower cubicles.
Install rail so bottom is at least 600mm above the floor for child safety.
Do not sit, stand, lean, or hang on product. Avoid damage to maintain function.
Ensure installation by a registered electrician and compliance with local regulations.
Locate 24V transformer in dry area; keep wiring connection leg under 2m.
Incorporate disconnection means; maintain 50mm clearance; no wires in wall cavity.
Connect electric power and turn on wall switch. Turn off when not in use.
Clean with a soft dry towel. Unit designed for continuous operation.
Surface temperature is high when towel warmer operates. Please be careful.
Read and understand manual before connecting to electricity supply.
Intended for domestic use only. Not for water, sauna, or shower cubicles.
Damaged wiring must be replaced by manufacturer or qualified person to avoid shock.
Do not sit, stand, lean, hang on product, or collide. Avoid damage.
Elderly, disabled persons require supervision during operation.
Do not attempt electrical repairs. Ensure hands are dry when unplugging.
Fix to timber stud, steel stud, or masonry. Plasterboard/cement sheeting alone is not recommended.
Stud walls require timber noggins at wiring connection leg position.
Attach Non-Electrical Legs with Fasteners and Allen key. Attach Electrical Leg with Flat Grub Screw.
Mark centre fixing points, ensure level. Fix brackets with Wall Screws and Anchors.
Push Leg Dressing into Legs before connecting wires. Insert wiring into Waterproof Connector.
Crimp connector button into main body. Wipe off excess waterproofing gel.
Slot rail openings into Wall Brackets. Secure with Pointed Grub Screws.
Use a damp cloth with water or soapy water. Do not use abrasive materials.
