!
Attention: Please do not power on your aircraft when calibrate the control stick for the
remote controller.
Warm tips:
Control sticks calibration has been completed by default. It is not
necessary to calibrate the control stick unless pilot has felt unnormal
stick travel.
Control Stick Calibration
How to calibrate the control sticks
Turn on the remote controller. Push down the calibration button and hold on for 3
seconds. The remote controller will send out 3 beep sounds; the indicator light of
the remote controller turns from flashing quickly to slowly. Maximum rotate both of
the left and right control stick to any direction for 2 circles. Then, again, push down
the calibration button and hold on for 3 seconds. The remote controller will send out
3 beep sounds; the indicator light of the remote controller turns from flashing slowly
to quickly, which means that control sticks calibration is completed.
( rotate for 2 circles at the same time)
To Next Page
