6
The helicopter
Insert the battery plug into the helicopter battery socket located at
the right side of the helicopter, then, the indicator light of the helicopter
will keep flashing rapidly, set the helicopter down to a platform.
Slide the power switch to “ON” position. To activate the remote
controller,slowly push up the throttle stick to the top and then push
it down to the bottom. The remote controller is activated once you hear
a beep sound.Then, the indicator light flashes rapidly while the remote
controller is sending out connectional signal.
When the whole auto signal connection process is finished, push up the
throttle stick slowly and the helicopter takes off.
When the power of the transmitter is weak, the battery power icon will
keep blinking and send out beep sound to remind user to change new
battery.
connector
Stabilizer bar
servo
rotor blade
searchlight
power socket
battery connector
landing gearcamera
User may push either of the control sticks to skip the auto signal
connection process once the helicopter finished signal connection.
Set the connection one by one. Otherwise, it may not be connected.
Once the transmitter is turned off, the connection procedure must be
repeated to operate the helicopter.
Please pull out the battery plug from the helicopter battery socket.
To avoid battery damage,please full charge the helicopter before
storing it.
Operational Tips
How to charge the helicopter
Preparation for flight
Transmitter battery low power prompt
Connect the charger to the AC power outlet, the indicator light will turn
green.Then, insert the plug of the battery cable into the port of the
charger and the indicator light will turn red. When the battery is full
charged, the light will turn green. Full charging takes about 3 hours.
To Next Page
Loading...
