MK MK-101 - Introduction

MK-101 Revision 4/01, Effective Date April 29, 2001 Page 26
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE:
1. New Maintenance:
Perform the following after initial purchase and operation of the MK-101.
2. Maintenance Following Use:
To extend the life of the MK-101, the following procedure should be performed after each use. Lubricate all
points listed below with light oils such as, 3 in 1, WD-40, etc.
* A GFCI wall socket is the preferred protective device.
Off
Position
ON/OFF
Switch
(A)
Check and adjust V-belt
tension Following 1
st
48 hours of
operation (See V-belt Inspection)
(A)
Ensure the ON/OFF Switch
is in the OFF position
(B)
Unplug MK-101*
(C)
Lubricate the Guide Bar
(A)
Lubricate the Roller
Wheel Assembly
Inspect
V-belt
GFCI
Guide Bar
Roller Wheel
Assembly