Need help?Do you have a question about the MKS Robin Nano and is the answer not in the manual?
General| Operating Voltage | 3.3V |
|---|---|
| Clock Speed | 72MHz |
| Microcontroller | STM32F103 |
| Driver Support | TMC2208, A4988 |
| Firmware | Marlin |
| Connectivity | USB, UART |
| Power Input | 12V-24V |
| Heated Bed Output | 1 |
| Fan Output | 2 |
| Communication Interfaces | USB, UART |
| Display Support | 12864 LCD, TFT |
Step-by-step guide on how to update the motherboard firmware using an SD card.
Essential initial settings for machine type, extruders, and travel limits.
Configuration options for stepper motors, movement, and endstops.
Parameters specific to Delta printer kinematics, including rod lengths and offsets.
Configuration for manual and automatic bed leveling procedures.
Explanation of the breakpoint resume function and UPS power considerations.
To Next Page
