SAFETY INSTRUCTIONS | 7
HOSES, LINES, AND TUBES
Do not pull on, or attempt to move equipment, with hydraulic hoses. Move power unit
closer to work if hoses do not reach.
Do not operate this equipment with hydraulic hoses that are damaged or kinked.
Replace damaged hoses immediately.
Do not lift, or support, hydraulic hoses with wire rope slings.
Do not pull kinks in the hoses. Kinks will reduce the hose safety factor by 50 percent.
Do not bend or strike high pressure lines. Do not install bent or damaged lines, tubes
or hoses.
Repair any loose or damaged fuel and oil lines, tubes and hoses. Leaks can cause res.
Inspect all lines, tubes and hoses carefully. Do not use your bare hands to check for
leaks. Tighten all connections to the recommended torque.
Check for the following:
- End ttings damaged, leaking or displaced.
- Outer covering chafed or cut and wire reinforcing exposed.
- Outer covering ballooning locally.
- Evidence of kinking or crushing.
Make sure that all clamps, guards and heat shields are installed correctly to prevent
vibration, rubbing against other parts, and excessive heat during operation.
OILS
Hot oil and components can cause personal injury. Do not allow hot oil or components
to contact the skin.
To Next Page
Loading...