MNC Chill Cube - Speaker Charging Procedure; Remote Control Setup; Bluetooth Device Pairing

CHARGING THE SPEAKER
1. LifttheportcoverandinserttheMICROUSBCHARGINGCABLEintothe
MICROUSB IN PORT on thespeaker.Plugthe MICROUSBCHARGING
CABLE’S USB connection into the included USB ADAPTERor into the
USBportonyourcomputer.Thespeakerwillbefullychargedinapprox-
imately8hours.
2. TheCHARGING LED INDICATORis RED while the speaker is charging.
Whenthespeakerisfullycharged,theCHARGINGLEDINDICATORturns
o.Forrsttimeuse,fullychargethespeaker.
3. Whenthebatteryislow,thespeakerwillannounce“LowBattery”.
REMOTE CONTROL SET UP
RemovetheinsulatortabundertheREMOTECONTROLBATTERYCOMPART-
MENT.
PAIRING YOUR DEVICE
1. PrepareyourdevicetopairusingBluetooth®technology,makingsure
thedeviceiswithin33feetofthespeaker.Refertoyourdevice’sowners
manualfordetailsifnecessary.
2. PressandholdthePOWER/LIGHTBUTTONonthespeakerfor3seconds
orpressthePOWERBUTTONontheremoteuntiltheBLUETOOTHLED
turnsonandstartsashing.Thespeakerwillannounce“Bluetooth”then
“WaitingforConnection”.
3. Select“MNC”onyourdevice.Ifprompted,use0000asaPINforthepair-
ingcode.
4. When“MNC”isselected,theBLUETOOTHLEDwillbesolidblueandthe
speakerwillannounce“BluetoothConnected”.
5. Topairadierentdevice,pressthePAIRINGBUTTONontheremote.The
BLUETOOTH LED will ash and the speaker will announce“Bluetooth
Disconnected” then“WaitingforConnection”.Followsteps 3 and4to
pairthedevice.