MOA SB50VB - Malfunctions and Solutions; Warranty

Sensor Bin - English manual
5
EN
DISPOSAL
Do not dispose of the device in normal domestic waste.
Dispose of the device over a registered waste disposal rm or through
your communal waste disposal facility.
Observe the currently valid regulations. In case of doubt, consult your
waste disposal facility.
WARRANTY
Dear Valued Customer,
Thank you very much for purchasing a MOA product.
We wish you to inform you that this product is covered by a warranty
which complies with all legal provisions concerning existing warranty
and consumer rights in the country where the product was purchased.
Should you nd any defect or malfunction of your MOA product,
please contact the appropriate Customer Care Center.
Sincerely yours,
The MOA Team
MALFUNCTIONS AND SOLUTIONS
Malfunction: The lid fails to open
Solutions:
- Check if the batteries are installed properly or if the batteries are in
good contact with springs.
- Check if the switch is turned on.
- Leave the inductive area for 10 seconds and then try again.
Malfunction: The lid fails to close
Solutions:
- Check if there is interferent in the inductive area.
- The circuit may be damp.Turn off the switch and put the lid in a
ventilated place until it is dry then try again.
Malfunction: The lid opens very slowly
Solutions:
- The batteries are running low, replace with new ones.
- Remarks:If the above solutions don’ t work,please consult local sales
agency.