Operating the cooler A40
14
I
➤ Position the gas cylinder vertically at a distance of at least 1 metre away
from the burner (on the back of the cooler).
➤ Check if the valve on the gas cylinder is closed.
➤ Connect the hose line to the head of the valve on the gas cylinder and the
cooler (fig. 3 1, page 4).
Use an open-ended spanner with the appropriate width for this.
➤ Make sure that the hose line
– Is not crushed or kinked
– Is a safe distance from the burner.
➤ Open the valve on the gas cylinder.
!
➤ Check all connections with a leakage test spray.
There are no leaks if no bubbles form.
➤ Ensure that
– The thermostat control for 220 V – 240 V operation (fig. 2 2, page 3)
is in the “0” position
– The battery plug is not connected.
➤ Press in the rotary switch (fig. 2 2, page 3), turn it past the “ ” symbol
and hold it in for approx. 15 – 20 s to force out any air in the hose connec-
tion.
➤ Turn the rotary switch towards “ ”, even if the flame is already burning.
✓ You will hear a clicking noise: the Piezo ignition is trying to light the flame.
When the flame is burning, the cooler is ready for use.
➤ If the flame does not ignite, repeat the procedure.
I
NOTE
The device is fitted with a pilot light. The gas supply is interrupted
when the flame goes out.
WARNING!
Never check for leaks with an open flame or near sources of igni-
tion.
NOTE
If it is not possible to light the gas with the Piezo lighter due to high
air humidity, you can light the gas burner with a match at the opening
in the back panel of the device when the rotary switch is pressed in.
To Next Page
Loading...
Need help?
General
