Mobicool DC Safety instructions
5
A
NOTICE!
Check that the voltage specification on the type plate
corresponds to that of the energy supply.
Only connect the cooling device to a DC power supply in the
vehicle with the DC cable.
Never pull the plug out of the socket by the cable.
Disconnect the cooling device and other power consuming
devices from the battery before connecting a quick charging
device.
Disconnect the cooling device or switch it off when you turn off
the engine. Otherwise you may discharge the battery.
The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
The insulation of the cooling device contains flammable cyclo-
pentane and requires special disposal procedures. Deliver the
cooling device at the end of its life-cycle to an appropriate recy-
cling.
2.2 Operating the cooling device safely
!
CAUTION!
Before starting the cooling device, ensure that the power supply
line and the plug are dry.
A
NOTICE!
Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for the purpose.
Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Danger of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation
on all four sides of the cooling device. Keep the ventilation area
free of any objects that could restrict the air flow to the cooling
components.
Do not place the cooling device in closed compartments or
areas with none or minimal air flow.
Ensure that the ventilation openings are not covered.
Do not fill the inner container with ice or fluids.
Never immerse the cooling device in water.
Mobicool-DC--O-16s.book Seite 5 Montag, 8. Januar 2018 6:16 18
To Next Page
Loading...
Need help?
General
