F15 Operation
9
6 Operation
!
I
6.1 Energy saving tips
Choose a well ventilated installation location which is protected against
direct sunlight.
If you want to set an increased energy efficiency and a limited cooling
capacity for the cooler unit, use the cooler’s ECO mode.
Allow warm food to cool down first before placing it in the device to keep
cool.
Do not open the cooling device more often than necessary.
Do not leave the cooler unit open for longer than necessary.
CAUTION! Health hazard!
Food may only be stored in its original packaging or in suitable
containers.
NOTE
Before starting your new cooling device for the first time, you
should clean it inside and outside with a damp cloth for hygien-
ic reasons (please also refer to the chapter “Cleaning and
maintenance” on page 11).
A few water drops may form inside the cooler if it has been
cooling for a lengthy period. This is normal because the mois-
ture in the air condenses to water when the temperature in the
cooler falls. The cooler is not defective. Wipe it out with a dry
cloth if necessary.
To Next Page
Loading...
Need help?
General
