Mobicool AC/DC Operation
9
I
I
6.1 Energy saving tips
Choose a well ventilated installation location which is protected against
direct sunlight.
If you want to set an increased energy efficiency and a limited cooling
capacity for the cooler unit, use the cooler’s ECO mode.
Allow warm food to cool down first before placing it in the device to keep
cool.
Do not open the cooling device more often than necessary.
Do not leave the cooler unit open for longer than necessary.
Remove individual drinks bottles through the bottle hatch, if present.
6.2 Using the cooler in DC mode
➤ Place the cooler on a firm base.
➤ Connect the DC cable to the cigarette lighter or the DC socket in the
vehicle.
Coolers without the additional heating feature
✓ The cooler starts cooling the interior.
➤ To switch off the cooler, disconnect the plug.
NOTE
Before starting your new cooling device for the first time, you
should clean it inside and outside with a damp cloth for hygien-
ic reasons (please also refer to the chapter “Cleaning and
maintenance” on page 11).
A few water drops may form inside the cooler if it has been
cooling for a lengthy period. This is normal because the mois-
ture in the air condenses to water when the temperature in the
cooler falls. The cooler is not defective. Wipe it out with a dry
cloth if necessary.
NOTE For coolers with fold in handles
If the handle is folded back or if the cooler is being carried, the lid
is locked. You can only open the lid when the handle is folded
forwards.
To Next Page
Loading...
Need help?
General
