Answer a Call:
During the ring tone, press Accept Button (1) for 1 second to answer the call.
End a Call:
Press End/Reject Button (2) for 1 second to end the call.
Voice Dial:
Important: Be sure the voice dialing function of your phone is activated. Record
at least one voice tag. (Kindly refer to the procedure in your phone’s manual.)
Important: Voice dialing entries must be stored in the phone’s memory, not on
the SIM card!
1. Press the Accept Button (1) for 1 second.
2. A voice dial beep will be heard on the kit to prompt the user to say the
voice tag of the contact to call.
3. Say the voice tag exactly as how you recorded it.
4. The voice will be played back to you, and then the phone will dial the
number automatically.
Note: Voice dial deactivation: Pressing Accept Button (1) for 1 second
activates voice dial but if you want to deactivate it, just press the same button
again for 1 second. The voice dial will be deactivated immediately.
Redial (For Handsfree Profile Phones only) :
Press Accept Button (1) for 3 seconds. The last dialed number will be redialed.
Reject a Call (For Handsfree Profile Phones only) :
During the ring tone, press End/Reject Button (2). The incoming call will be
rejected.
Volume Setting:
Increase or decrease the volume by pressing the Volume Up (8) or Volume
Down (7) button. Press repeatedly until desired level is reached.
Audio Transfer (For Handsfree Profile Phones only) :
During an ongoing call, you can transfer the audio.
Kit to Phone: Press the Accept Button (1) for 3 seconds. The audio will be
transferred to the phone.
Phone to Kit: Press the Accept Button (1) for 1 second. The audio will be
transferred to kit.
To Next Page
Loading...