EasyManua.ls Logo

MobilePower 4035 - AC Charging At Home; DC Charging In Your Vehicle; DC Charger Fuse Replacement

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sheet 7 of 8
• MakecertainthatthePowerSwitchissettothemiddle“O”off
position.
• Do not charge near ammable material, open ames or any
locationwhichmayaccumulateammablefumes.
• Makecertaintheelectricaloutletlocatedinapotentiallywetor
moist area that is to be used to charge this device, is protected by
aGroundFaultCircuitInterrupter(GFCI).
• Makesurethatbothboosterclampsaresecurelyplacedintheir
designated storage compartments when not in use and during
the charging period.
A. AC Charging At Home with 110 Volt Charger
1. Keep the Power Switch in middle “O” off position while charging.
2. Insert the AC charger round plug into the Spotlight Charging Port
located at the back of the spotlight.
3. Connect the 110 Volt AC Charger into the 110 Volt AC home
receptacle.
4. Fully charge the spotlight according to the following charging
schedule:
Firsttimecharge:...................................................24hours
Rechargeandsubsequentcharge:.......................18hours
5. Unplug the AC charger from the 110 Volt receptacle first and then
remove the round plug from the Spotlight Charging Port.
B. DC Charging In Your Vehicle with 12 Volt Charger
1. Keep the Power Switch in middle “O” off position while charging.
2. Insert the 12 Volt DC Charger round Plug into the Spotlight
Charging Port located at the back of the spotlight.
3. Connectthe12VoltDCChargerPlugintothevehiclecigarette
lighter or 12 Volt accessory port.
4. Fully charge the Spotlight internal battery for 8 hours while the
vehicle engine is running.
5. Unplug the DC charger from the vehicle cigarette lighter or 12 Volt
accessory port first and then remove the round plug from the
Spotlight Charging Port.
12 VOLT DC CHARGER ADAPTOR FUSE REPLACEMENT:
1. Unscrew the retainer ring at the tip of the 12 Volt DC charger
plug.
2. Replace the internal glass fuse with the same grade Fuse rated
at 2 AMP.