Mobotix AllroundDual M16B - 3.4.3 Special M16 Configuration in the Browser

97
Virtual PTZ and Full Image Recording
3.4.3 SpecialM16CongurationintheBrowser
M16andDierentSensorModules
A range of combination options are provided that change
theavailabledisplaymodesandcongurationpossibilities
byusingtheMOBOTIXM16withdierentsensormodules.
Because of this, a M16 automatically detects which sensor
modules are installed and proceeds as follows:
• Whenthecameraisstartedforthersttime,itdetects
the connected sensor modules and captures their data
(focal length, day or night version).
• If only one sensor module is connected, the camera acts
as a mono camera (meaning that there is no automatic
day/night switching, etc.).
• Ifthereisnochangewithintherst12hoursofopera-
tion, the camera writes the details of these sensor mod-
ulestothecameraconguration.
• With every restart, the camera checks if the stored sen-
sormodulesarepresent.Ifthesensorconguration
has changed in the meantime (e.g., because a sensor module has been exchanged),
the camera shows a corresponding message in the live image . To store the changed
sensorcongurationinthecamera,proceedasdescribedattheendofSection3.4.3,
«SpecialM16CongurationintheBrowser».
CongurationoftheM16BasicParametersforHemisphericSensorModules
Thanks to its hemispherical lens, the MOBOTIX M16 provides certain spe-
cialcongurationoptionsfortheimagesettings.Dependingonwhere
thecameraisinstalled(ceiling,walloroor)and
on the live image display preferred by the user,
certain important basic settings and, if necessary,
theiradjustmentmustbeconguredwhenaM16
isrstinstalled.
Sensor module B016* Sensor modules B036*, B041*,
B061*, B079*, B119*, B237*
Sensor module B500*