Connect the 3M resistor to terminals #4 and #5. This resistor should be pushed down to allow room for
other components to be mounted later in the instructions. Do not solder at #5, yet.
Connect a 10K resistor to terminals #5 and #6. Do not solder at #5, yet.
Connect the MPSA13 transistor to terminals #3, #4 and #5 as listed below. Solder all of the connections
at these terminals now.
Terminals #3: Emitter
Terminals #4: Base
Terminals #5: Collector
MPS
A13
E
B
C
Connect the 0.1µF cap to terminals #7 and #11. This should be mounted upside down to allow room for
other components to be mounted later in the instructions. Do not solder at #11, yet.
Connect a 10K resistor to terminals #9 and #10. Do not solder at #10, yet.
2N
3904
E B C
Connect the 2N3904 transistor to terminals #10, #11 and #12 as listed below. Solder all of the
connections at these terminals now.
Terminals #10: Emitter
Terminals #11: Base
Terminals #12: Collector
2N
3906
E
B
C
Connect the 2N3906 transistor to terminals #12, #13 and #14 as listed below. Solder all of the
connections at these terminals now.
Terminals #12: Collector
Terminals #13: Base
Terminals #14: Emitter
Connect the remaining 10K resistor to terminals #14 and #15.
Connect the 330pF cap to terminals #11 and #12.
Connect the 820K resistor to terminals #12 and #13.
Connect the 0.22µF cap to terminals #12 and #17. Mount this cap upside down.
Connect the positive (+) lead of the 22µF cap to 1K pot lug 2 and
connect the negative (-) side to 1K pot lug 3. Mount it so that its leads
are not at risk of shorting out against the pot's body.
22µF 50V
(-) (+)
Connect one end of the 1.5K resistor to both lugs 2 and 3 of the 100K “tone” pot. Connect the other end
to terminal #19.
Connect the .0039µF cap to terminals #18 and #19.
9
Connect the 180Ω resistor from terminal #6 to footswitch lug 4.
Connect the 0.1µF cap to terminals #2 and #4. This should be mounted upside down to allow room for
other components to be mounted later in the instructions. There will be two more components
connected to terminal #4 so do not solder at #4, yet.
To Next Page
Loading...
