Mod THE PERSUADER - User Manual

1 Copyright © 2014 by modkitsdiy.com
Use these instructions to learn:
How to build a tube preamp pedal
The Persuader uses a gain boost circuit driving a 12AX7 preamp tube operating in starved plate mode to go
from clean, warm tone to smooth, real tube overdrive.
THE PERSUADER (K-930)
Signal Input
(From Guitar)
Unplug when not in use
to save battery life.
9 VDC
CENTER (-)
ADAPTER
Signal Output
(To Amplifier)
Warning: This circuit was designed for use with a 9 VDC power supply only.

Summary

Parts List 1

Parts List 2

Final Assembly Reference Drawing

Soldering Tips

De-Soldering Tip

Guide for removing solder joints using specific tools and methods.

Section 1: Mount Jacks and Terminal Strip Components

Section 2: Mount Potentiometer, Footswitch, and Power Jack

Section 3: Connect 5 KL Potentiometer

Section 4: Mount Tube Socket, Shield, and Terminal Strips

Section 5: Connect DC Power Components

Section 6: Vacuum Tube Wiring Connections

Section 7: Mount Components in Vacuum Tube Section

Section 8: Wire Output Jack and Footswitch Connections

Section 9: Finishing Up

Mod THE PERSUADER Specifications