20
Step 3 – Connect the cables to their respective phono jacks
Please refer to assembly Drawing 7.
Connect the 12" cable from the reverb tank’s “OUT” connector to the phono jack closest to V3.
Connect the 14 ½" cable from the reverb tank’s “IN” connector to the other phono jack on top of the unit.
SECTION 8 – Finishing Up
Plug the tubes into their respective sockets as indicated on Drawing 7. There is only one 12AT7 (a.k.a.
ECC81) and it should be plugged into socket V2. All the other tubes are 12AX7's (a.k.a. ECC83).
Plug the detachable power cord into its receptacle on the rear panel.
Note: The Wave is capable of delivering extreme levels of reverb. It is best to keep the Wave off of your
speaker cabinet if you plan to play at loud volumes with the reverb controls turned up past half-way.
Otherwise, the mechanical vibrations may cause oscillations.
To Next Page
Loading...