English 21
Cleaning & Maintenance
1. Clean the dirt on the panel regularly (it is advised twice a day).
2. The burners should be cleaned at regular interval, which is suggested to carry out once a week.
3. The out surface of the stainless steel can be cleaned with warm solution of water and soap, and
rinse it clean completely. Do not clean it with high pressure water jet.
4. When cleaning, do not use abrasive detergent, brushes or scrapers to clean the stainless steel
surface, because the remaining iron particles could cause rust from it. Nor use any chloride
products (for instance, bleacher, hydrochloric acid and the like), even if these products have been
diluted. Besides, wipe it according to the direction of the satin weave.
5. Do not modify the necessary air volume for combustion.
6. After cleaning, please clean up the liquid or dirt in the fire outlet with thin wire to eliminate the
insecurity factors which may cause incomplete combustion or impede the spread of flame.
7. Anytime when stop using it, the gas supply shall be cut off.
8. If the device is out of use for a long time, it is advisable to wipe all the stainless steel surface with
a cloth soaked in gasoline. And then store it in a well ventilated warehouse.
9. It is suggested to carry out a complete inspection of the device at least once a year by
professional technician.
10. Over 90% of the device is made of metals (stainless steel, iron, aluminum and plated metal
sheet) and these metals can be recycled after being disposed in designated treatment plant
according to the national appliance installation standard in force so that please do not discard
them.
Part 4: Cleaning and Maintenance
To Next Page
Loading...