5
• Insert the rubber hose at the end of the gas cylinder and regulator ot the
other end of the rubber. Try to get as deep as possible then tighten the
rubber hose with hose clamp.
• Open clamp on the gas cylinder. If there is a leak or strong gas smell, close
the gas tap immediately, then open the window so that gas comes out of
the kitchen room.
• The stove is ready to operate.
Knob Control
The amount of gas flow in the burner can be set on the knob as shown below:
1.
To decrease/increase the fire on turned on burner:
Turn the knob to position the maximum fire sign or direction of the position of the
minimum fire sign.
2.
To use the minimum fire:
Turn the knob to gas flow – Minimum .
ATTENTION
• To avoid gas leak, please use gas standardized hose with gas safety
device.
• Use the hose and regulator that are specified to avoid gas leak.
• Do not use a high pressure regulator.
To Next Page
Loading...
