FR-W1810Vortex Instructions12
1. Remove 1 of 2 screws from the bottom of mounting bracket and
save for use in section 9. Loosen the other screw (Fig. 2).
2. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in (Fig. 2A).
3. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box (Fig.2A).
4. Remove the clevis pin and cotter pin and loosen the two collar
screws from the motor collar (Fig. 2B).
5. Feed motor wires through coupling cover, canopy ring,
and canopy.
6. Feed motor wires through downrod assembly.
7. Thread the downrod assembly onto motor collar. Align the holes
of down- rod and collar and insert the cotter pin and clevis pin.
Tighten the two collar screws (Fig. 2B).
WARNING: Failure to properly install the cotter pin
and/or tighten the screws could result in the fan loosening
and possibly falling.
2. Hanging the Fan
Remember to disconnect the power at the circuit breaker.
To Next Page
Loading...
