Need help?Do you have a question about the MoFi Electronics UltraDeck and is the answer not in the manual?
General| Type | Belt-Drive Turntable |
|---|---|
| Platter Material | Aluminum |
| Outputs | RCA |
| Motor | DC Motor |
| Speeds | 33 1/3, 45 RPM |
| Cartridge | MoFi MasterTracker (optional) |
Ensure the UltraDeck™ is placed on a level surface for optimal performance and setup.
If the cartridge is not pre-installed, follow the manufacturer's specific installation instructions.
Carefully place the Delrin® platter and install the turntable belt for correct speed operation.
Balance the tonearm and adjust the counterweight using a stylus force gauge for precise tracking.
Attach the anti-skate weight to the pin and select the correct notch based on cartridge weight for balanced playback.
Adjust the tonearm height by loosening the base hex screw until the arm is parallel to the record surface.
Adjust the headshell for correct azimuth by loosening the armtube hex screw until parallel to the record surface.
Connect RCA interconnects and ground wire to the preamp, and plug the power cord into an outlet or conditioner.
Use a bubble level on the platter and adjust each foot to ensure the turntable is perfectly level.
Gently clean the stylus back-to-front after each play using the supplied brush and consider a liquid cleaner.
Use the dustcover when not in use; remove it during playback for optimal sound quality.
To Next Page