Front Lines
Record Surface
If UltraDeck™ came with
UltraTracker™ preinstalled,
the following steps were
completed at the factory
After setting tracking force and
anti-skate, adjust the tonearm’s
height. Loosen the hex screw
located at the base of the tonearm
to raise or lower the arm height,
and tighten once the arm is
parallel to the record surface.
Next, adjust your headshell and
cartridge for correct azimuth.
Loosen the hex screw located
under the armtube, then adjust
the headshell as needed until it is
parallel to the record surface.
VTA AND AZIMUTH
To Next Page
Loading...