MoFi Network - MOFI4500 Router
Overview
This article provides a quick guidance on MoFi Network MOFI4500 Router setup and configuration to connect it to Swift
Navigation GNSS receiver and obtain corrections from Skylark or a third party RTK correction service.
Fig 1. MOFI4500-4GXeLTEv2 Router
General Information
The MoFi Network Router MOFI4500-4GXeLTEv2 does not include internal cell modem. For the Internet access it can
either operate as a WiFi client and connect to a WiFi hotspot (in the cell phone for example) or work with cell modem USB
dongle plugged directly to the router.
MoFi Network (http://mofinetwork.com) manufactures also other routers with built-in cell modems but they were not
tested by Swift Navigation.
At Swift we use MoFi routers with Verizon USB cell modem dongles in several test setups with very good results.
The router has four Ethernet RJ45 ports.
Hardware Setup
Recommended Piksi Multi / Duro setup is depicted in the diagram below.
www.swiftnav.com | support@swiftnav.com
©2018 Swift Navigation, Inc. All rights reserved | Version 1.1 | Swift Navigation, Inc. Proprietary
To Next Page
Need help?
General
