Why will my MoJack Lifting Systems jack not lift the load?
If your MoJack Lifting System jack is not lifting the load, it might be due to a release valve that isn't tightly closed. Make sure the release valve is securely closed. Another possibility is an overload condition, in which case you should remedy the overload.
Why does my MoJack Lifting Systems jack bleed off after lifting?
If your MoJack Lifting System jack lowers after lifting, it could be due to a few reasons. First, check that the release valve is tightly closed. If it continues to bleed, there might be an overload condition that needs to be addressed. In case the issue persists, it might be a hydraulic unit malfunction.
How to improve poor lift performance of MoJack Lifting Systems?
If you're experiencing poor lift performance with your MoJack Lifting Systems jack, it could be due to a low fluid level. Ensure that the fluid level is at the proper level. Another potential cause is air trapped in the system. With the ram fully retracted, remove the oil filler plug to let any pressurized air escape, then reinstall the oil filler plug.
What to do if MoJack Lifting Systems jack will not lower after unloading?
If your MoJack Lifting Systems jack won't lower after unloading, it could be because the reservoir is overfilled. You should drain the fluid to the proper level. Another potential cause is binding linkages. Try cleaning and lubricating the moving parts.
Why my MoJack Lifting Systems will not lift to full extension?
If your MoJack Lifting Systems jack isn't lifting to its full extension, the fluid level might be low. Make sure that the fluid level is at the proper level.
General safety and operating instructions for the MoJack HDL lift.
Details limited warranty, exclusions, period, and service procedures.
Explains how to obtain service, contact MoJack, and the process for returns and refunds.
Instructions for unpacking the lift and verifying all parts are present.
Guide on attaching the wheel pads to the T-Bar using push pins.
Details on how to attach the safety straps to the wheel pads.
How to use safety straps to secure the mower's front tires to the wheel pads.
Guide on operating the handle to raise the mower to the desired height.
Instructions on how to safely lower the mower using the hydraulic release valve.
Steps for replacing, adding, and changing hydraulic cylinder oil.
Common issues, corrective actions, and recommendations for storing the lift.
General| Product Type | Lawn Mower Lift |
|---|---|
| Lift Height | 25 inches |
| Material | Steel |
| Dimensions | 40 x 19 x 8 inches |
| Power Source | Manual |
| Weight | 35 lbs |
| Lifting Height | 25 inches |
To Next Page
