Hand Crimp Tool for 1.25mm (.049") Pitch Wire-to-Board Crimp Terminals
Doc No: ATS-20021803HM Release Date: 01-27-17 UNCONTROLLED COPY Page 5 of 6
Revision: A Revision Date: 01-27-17
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is NOT intended for
production use. Repetitive use of this tool should be avoided.
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
Applications for the Modular Crimp Head
WARNING: NEVER operate, service, install, or adjust this Modular Crimp Head without proper instruction
and without first reading and understanding the instructions in the proper Manual or Specification Sheet.
See Chart below for the correct Manual or Specification Sheet.
WARNING: NEVER install tooling or service this tool while it is into any power source. Disconnect the
power by unplugging or turn off the Actuator from its power source.
CAUTION: Keep fingers away from the crimping area when operating this tool. It may cause severe injury.
CAUTION: Wear safety glasses when operating or serving this tool.
The chart below shows all applications for this Modular Crimp Head.
Battery Power Tool (110 V)
Battery Power Crimp Adapter
Battery Power Tool (220 V)
Battery Power Crimp Adapter
Applications for the Modular Crimp Head
HAND CRIMP
FRAME LONG
OR SHORT
BATTERY
POWER
CRIMP
ADAPTER
To Next Page
Loading...