How to turn on Moller Medical LiquoGuard®7 Medical Equipment?
If your Moller Medical LiquoGuard®7 isn't turning on, there are a few things you can check: * First, ensure the device is switched on using the On/Off switch. * Verify the power supply lead is correctly connected. * Try using a different plug connector. * Inspect the leads for any damage. * Finally, ensure the batteries of the LiquoGuard®7 are fully charged.
What to do if the touchscreen of Moller Medical LiquoGuard®7 Medical Equipment does not respond?
If the touchscreen on your Moller Medical LiquoGuard®7 Medical Equipment is not responding, try the following: * If you're wearing gloves, remove them and try using the touchscreen again. * Restart the LiquoGuard®7 using the On/Off switch. If the issue persists, a Service Technician should check the device.
Why is the Moller Medical LiquoGuard®7 Medical Equipment pump not working?
If the pump on your Moller Medical LiquoGuard®7 Medical Equipment isn't working even when Pcsf (or ICP) is greater than Pset, it might be due to the following reasons: * The pump may be in Pause mode. Press the softkey Pause/Start to initiate drainage. * The device could be performing a flow resistance measurement. * The pump is designed to function only when the measured CSF pressure (Pcsf (or ICP)) exceeds Pset.
General| Brand | Moller Medical |
|---|---|
| Model | LiquoGuard 7 |
| Category | Medical Equipment |
| Language | English |
Lists clinical conditions for which temporary intrathecal CSF drainage is indicated.
Step-by-step guide for preparing the sterile tubing set for connection.
Guides the connection of the catheter to the tubing system.
Explains how to position and secure the pressure sensor housing for accurate measurements.
Explains the settings and principles for pressure-controlled drainage.
Details the settings and principles for volume-controlled drainage.
Describes the visual and auditory signals generated when an alarm occurs.
Identifies common faults and provides solutions.
Contact information and procedures for device service and support.
Instructions and approved agents for cleaning and disinfecting the device.
To Next Page
