To Next PageTo Next PageHow to turn on Moller Medical LiquoGuard®7 Medical Equipment?
If your Moller Medical LiquoGuard®7 isn't turning on, there are a few things you can check: * First, ensure the device is switched on using the On/Off switch. * Verify the power supply lead is correctly connected. * Try using a different plug connector. * Inspect the leads for any damage. * Finally, ensure the batteries of the LiquoGuard®7 are fully charged.
What to do if the touchscreen of Moller Medical LiquoGuard®7 Medical Equipment does not respond?
If the touchscreen on your Moller Medical LiquoGuard®7 Medical Equipment is not responding, try the following: * If you're wearing gloves, remove them and try using the touchscreen again. * Restart the LiquoGuard®7 using the On/Off switch. If the issue persists, a Service Technician should check the device.
Why is the Moller Medical LiquoGuard®7 Medical Equipment pump not working?
If the pump on your Moller Medical LiquoGuard®7 Medical Equipment isn't working even when Pcsf (or ICP) is greater than Pset, it might be due to the following reasons: * The pump may be in Pause mode. Press the softkey Pause/Start to initiate drainage. * The device could be performing a flow resistance measurement. * The pump is designed to function only when the measured CSF pressure (Pcsf (or ICP)) exceeds Pset.
General| Brand | Moller Medical |
|---|---|
| Model | LiquoGuard 7 |
| Category | Medical Equipment |
| Language | English |
