6
• Do not use it in the dark and in bad weather. Do not use the bike around stairs and steps.
• Do not drag the bike around from a bumper of a car or other vehicle.
• The bike is fi t for one person. The bike can be only used by one person at a time.
• Make sure that the child is wearing proper shoes and a helmet fi t for the child and protective pads
(elbow pads, knee pads, etc.). Make sure that the shoes fi t properly and have no loose elements, for
instance, laces, that may get caught in the elements of the bike.
• It is advised to use high-visibility items.
• It is crucial to make sure that while riding the bike child do not take their hands off the handles. Riding
a bike with no handlebars can cause serious injuries for the child.
• Do not use the bike in wet, extremely cold, or hot places.
• Keep away from fi re.
WARRANTY EXCLUSIONS AND LIMITATIONS
We are responsible for the quality of our products. Our warranty does not include damages caused by
improper use of the product or mechanical damages.
WARRANTY
The manufacturer gives a 2-year warranty for the product.
COMPONENTS
1. handlebar with tube and grips x 1
2. short metal pin x 1
3. long metal pin x 1
4. metal fl at washer x 4
5. secure ring x 2
6. body x 1
7. wheel cover x 4
8. wheel x 4
CORRECT ASSEMBLY OF THE PRODUCT
Read the instruction carefully before you use the product. To avoid injuries, please follow the manual.
The bike can be used for children up to 20 kg. The bicycle seat has to be suited to the child’s height so
that they reach the fl oor with both legs while sitting.
ASSEMBLY OF THE PRODUCT
1. Check that all parts are included and that nothing is missing
2. Make sure no part is damaged
3. Place a fl at metal washer on the shorter metal pin, then thread it over the wheel (all wheels are the
same for both front and rear of the vehicle) and the rear body as shown in Figure 1-2.
4. Put another circle on the protruding metal rod on the other side, then slide on a fl at metal washer
and a securing ring.
5. Put the pads on the outside of the mounted rear wheels by pressing the protruding parts into the
EN
To Next Page
Loading...
Need help?
General
