Need help?Do you have a question about the Monacor SAM-502 and is the answer not in the manual?
Details microphone input, grounding, and inputs for channels 1-4 (Phono, CD, Tape, Tuner, Video).
Describes output jacks (REC, OUT), VU meter, lamp jack, and headphone connection.
Covers input selectors, mic level, channel faders, monitor selection, and headphone volume.
Explains equalizer, master/balance controls, power LED, power switch, fuse, and power cable.
Guide for initial setup including talkover switch, fader adjustment, and output level setting.
Adjusting tone controls for outputs and connecting console lighting.
Details microphone input, grounding, and inputs for channels 1-4 (Phono, CD, Tape, Tuner, Video).
Describes output jacks (REC, OUT), VU meter, lamp jack, and headphone connection.
Covers input selectors, mic level, channel faders, monitor selection, and headphone volume.
Explains equalizer, master/balance controls, power LED, power switch, fuse, and power cable.
Guide for initial setup including talkover switch, fader adjustment, and output level setting.
Adjusting tone controls for outputs and connecting console lighting.
General| Channels | 5 |
|---|---|
| Phantom Power | Yes |
| Frequency range | 20 Hz - 20 kHz |
| Total Harmonic Distortion | <0.5% |
| Microphone Inputs | 2 |
| Line Inputs | 3 |
| Rated output power | 2 x 50 W |
| Outputs | 1 x RCA |
| Power Supply | 230 V, 50 Hz |
| Input sensitivity | 1.5 mV (mic), 150 mV (line) |
To Next Page
