To Next PageTo Next Page
Need help?Do you have a question about the Monacor WSA-10BT and is the answer not in the manual?
Includes warnings for power supply voltage, suitability for indoor use only, and handling damaged units.
Connect the receiver to the audio system via Toslink, Coaxial, or Analog outputs using supplied cables.
Connect the power supply unit to the receiver and a mains socket to switch it on.
Activate Bluetooth on the source device and pair it with the WSA-10BT, using '0000' if prompted.
After successful pairing, the LED lights permanently. Automatic reconnection supports up to 10 devices.
Includes warnings for power supply voltage, suitability for indoor use only, and handling damaged units.
Connect the receiver to the audio system via Toslink, Coaxial, or Analog outputs using supplied cables.
Connect the power supply unit to the receiver and a mains socket to switch it on.
Activate Bluetooth on the source device and pair it with the WSA-10BT, using '0000' if prompted.
After successful pairing, the LED lights permanently. Automatic reconnection supports up to 10 devices.
General| Type | Bluetooth receiver |
|---|---|
| Bluetooth Version | 4.0 |
| Frequency Response | 20 Hz - 20 kHz |
| Bluetooth Profiles | A2DP |
| Frequency Range | 2402-2480 MHz |
| Power Supply | 5V DC (USB) |
| Output | 3.5 mm Jack |
