To Next PageTo Next Page
Need help?Do you have a question about the Monacor WSA-20BT and is the answer not in the manual?
DC 5V input for power supply via the provided unit.
The antenna for receiving Bluetooth signals.
6.3 mm jack for audio output with line level.
Button for pairing mode; ring indicates pairing status (flashing/lighting).
Power supply uses dangerous mains voltage; servicing by skilled personnel only.
Suitable for indoor use only; protect against water, humidity, and heat.
Disconnect immediately if damaged or malfunctioning; repair by skilled personnel.
Use a dry, soft cloth only; never use water or chemicals.
Position receiver, attach antenna vertically.
Connect receiver output to audio system input.
Connect power supply unit to DC 5V jack and mains socket.
Press and hold PAIR button for 3 seconds to activate pairing mode.
Activate Bluetooth on source, pair with WSA-20BT; use '0000' if PIN is requested.
Start audio reproduction on source, adjust volume.
Audio frequency range, THD, channel separation.
Line level output, 6.3 mm balanced jack.
Bluetooth V4.0, supported profiles (A2DP, AVRCP, DI, HFP, HSP).
Transmission frequency, receiver sensitivity, and effective range.
Dimensions without antenna and weight.
DC 5V input for power supply via the provided unit.
The antenna for receiving Bluetooth signals.
6.3 mm jack for audio output with line level.
Button for pairing mode; ring indicates pairing status (flashing/lighting).
Power supply uses dangerous mains voltage; servicing by skilled personnel only.
Suitable for indoor use only; protect against water, humidity, and heat.
Disconnect immediately if damaged or malfunctioning; repair by skilled personnel.
Use a dry, soft cloth only; never use water or chemicals.
Position receiver, attach antenna vertically.
Connect receiver output to audio system input.
Connect power supply unit to DC 5V jack and mains socket.
Press and hold PAIR button for 3 seconds to activate pairing mode.
Activate Bluetooth on source, pair with WSA-20BT; use '0000' if PIN is requested.
Start audio reproduction on source, adjust volume.
Audio frequency range, THD, channel separation.
Line level output, 6.3 mm balanced jack.
Bluetooth V4.0, supported profiles (A2DP, AVRCP, DI, HFP, HSP).
Transmission frequency, receiver sensitivity, and effective range.
Dimensions without antenna and weight.
General| Type | Bluetooth Receiver |
|---|---|
| Bluetooth | Yes |
| Audio format via Bluetooth | A2DP |
| Frequency Response | 20 Hz - 20 kHz |
| THD | < 0.1% |
| S/N ratio | > 90 dB |
| Signal-to-Noise Ratio | > 90 dB |
| Output Power | 2 x 20 W |
| Power Supply | 12 V DC |
| Admiss. ambient temp. | 0 - 40 °C |
| Dimensions | 100 x 100 x 30 mm |
| Weight | 200 g |
| Connections | 3.5 mm jack, RCA |
