Meter instructions
KEYS AND FUNCTIONS
MODE key
Use the MODE key to cycle through the functions.
SET key
Pressing this key will make it possible to set TIME
and TOTAL COUNT. If you hold down this key for
two seconds you can advance the function value at a
faster rate.
Programming exercise time:
Press MODE key to advance to TIME function, and
use SET to enter your desired time. Each press of SET
will advance time by one minute. When pedalling is
started, measurement of remaining exercise time will
begin and the unit will count down to 0 at which time
beeper will sound for five seconds.
Programming TOTAL COUNT:
Press MODE key to advance to TOTAL COUNT
function, and use SET to enter your desired value.
Each press of the SET will increase the value by 10.
When the pedals / handles are rotated the countdown
of number of turns automatically start and count
down to 0 and a beep will be heard for five seconds.
RESET key
The RESET key will clear the values for TIME and
TOTAL COUNT individually.
NOTE!
Display will return to normal when not pressed 1.
any key for five seconds, or trainer is not used.
The meter starts automatically when a key is 2.
pushed, or if the bike is used and the meter gets
an indication of pedal movement.
Auto shut off function when not pressed any key 3.
or device not used for four minutes.
Do not expose the meter to direct sunlight or extremely
high temperature. Do not use any dissolvents when
cleaning. Use only dry cloth.
Display
Pedal revolution
(RPM)
0 - 250 rev./min.
TOTAL COUNT 9999 rev. total
TIME 0:00-99:59 min:sec
Batteries: 1.5 V x 2, R6 (AA)
Storing temperature: -10º C - +60º C
Operating temperature: 0º C - +50º C
To Next Page
Loading...
