Money Controls SR5i User Manual

SR5i Technical Manual TSP095.doc Issue 1.0 – July 2004
This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by
any means, electronic or otherwise, without the written permission of Money Controls Ltd. Money
Controls Ltd does not accept liability for any errors or omissions contained within this document.
Money Controls Ltd shall not incur any penalties arising out of the adherence to, interpretation of, or
reliance on, this standard. Money Controls Ltd will provide full support for this product when used as
described within this document. Use in applications not covered or outside the scope of this document
may not be supported. Money Controls Ltd. reserves the right to amend, improve or change the
product referred to within this document or the document itself at any time.
©Money Controls 2004. All rights reserved.

Money Controls SR5i Specifications

General

Brand	Money Controls
Model	SR5i
Category	Cash Counters & Coin Sorters
Language	English

Summary

Diary of Changes

Product Operation Overview

Electrical Connections

Electrical Interface Requirements

Accept Common (COM A) Input

Describes the COM A input's function and polarity selection for accept signals.

Alarms and Diagnostics

Power-up Diagnostics

Details the self-check performed at power-up and potential fault conditions.

Parallel Interface Modes

Parallel Interface Mode 1 Configuration

Details the configuration and outputs for SR5i Mode 1, compatible with C435.

Parallel Interface Mode 2 Configuration

Details the configuration and outputs for SR5i Mode 2, compatible with BACTA standard.

Coin Acceptance Control

Inhibit Lines Functionality

Explains how inhibit inputs control coin acceptance based on programmed settings.

Bank Select Parallel Inputs

Details bank selection for coin management and inhibition in Mode 1.

Inhibit Options Configuration

Describes special inhibit options stored in EEPROM for flexible coin setup.

Coin Sorting Mechanisms

4-way Sorter Operation

Explains the 4-path coin sorting mechanism and configuration options.

8-way Sorter with Active Manifold

Details the 8-path sorting using an active manifold and EEPROM programming.

Sorter Path Control

4-Way Sorter Path Overrides

Describes how to override the 4-way sorter paths via specific inputs.

Sorting Modes and Configuration

Routing Plug for 4-way Sorting

Explains the use of the routing plug for 4-way sorting and path connections.

EEPROM Sorting Mode Configuration

Describes sorting configurations using EEPROM for 4-way and 8-way sorting.

RS232 Communication Interface

RS232 PC Connection Details

Provides recommended wiring diagrams for connecting to a PC via RS232.

Flash Programming Interface

Flash Programming Wiring

Provides wiring instructions for flash programming the SR5i processor.

Bank Select Switches Configuration

Rotary Switch Configuration Options

Token Group Selection via Rotary Switch

Explains how to select token groups using the rotary switch positions.

Rotary Switch Settings for Operation

Alarm and Rundown Settings (Position D)

Details how to configure alarm and rundown settings using the rotary switch.

Token Programming

Teach and Run Token Programming

Guides on programming new tokens using the Teach and Run™ feature.

ccTalk Communication Protocol

ccTalk Serial Interface

Describes the serial interface for programming and machine communication via ccTalk.

ccTalk Serial Commands Reference

ccTalk Error and Fault Codes

ccTalk Error Codes

Lists and explains various error codes encountered in ccTalk communication.

ccTalk Fault Codes

Lists and explains different fault codes related to the acceptor's hardware.

ccTalk Interface Circuit Designs

ccTalk Standard Interface Circuit

Details the standard ccTalk interface circuit using an open-collector transistor.

Servicing and Maintenance

Front Entry Removal and Refitting

Describes the steps for removing and refitting the SR5i front entry mechanism.

Top Entry Removal and Refitting

Details the procedure for removing and refitting the SR5i top entry mechanism.

Troubleshooting Guide

Mechanical Specifications

Coin and Token Size Acceptance

Provides a graph showing the accepted range of coin and token dimensions.

Product Dimensions