To Next PageTo Next Page
Need help?Do you have a question about the Money Controls SR5 and is the answer not in the manual?
General| Brand | Money Controls |
|---|---|
| Model | SR5 |
| Category | Cash Counters & Coin Sorters |
| Language | English |
Describes the configuration for standard inputs like Inhibits, Bank Select, Diagnostics, and Overrides.
Details the self-check procedures performed by the SR5 upon startup, including EEPROM and sensor checks.
Explains the function of the Ident pin for host machine identification and binary credit code output.
Details the output signals for accepted coins and their electrical characteristics.
Configures the SR5 for 5 coin mode or 16 coin mode operation via a dedicated input.
Controls whether programmed coins are accepted or rejected based on input states.
Manages coin acceptance based on banks of 8, linked to inhibit inputs for modes 1, 4, 7, and 8.
Describes the standard sorting mechanism that channels coins into one of four output paths.
Details sorting coins into up to eight paths using an active manifold in conjunction with the sorter.
Allows overriding the default sorting paths (A-D) for the 4-way sorter.
Enables overriding sorting paths for the 8-way sorter, affecting routes 1 through 7.
Uses a routing connector to define coin paths for 4-way sorting, with specific pin assignments.
Configures sorting paths directly in the EEPROM for 4 or 8-way sorting.
Describes the cctalk serial communication for programming and machine interaction, not usable with parallel interface.
Tests inhibit and accept lines in a loop-back configuration to assess inductive noise.
Checks the operation of solenoid drives and displays the status of inductive coils.
Verifies the functionality of various opto-electronic devices like DCE coin/token optos and sorter optos.
Selects pre-programmed token groups or enables token teaching via rotary switch positions.
Allows programming a new token type directly on-site using position F.
Configures alarm activation and rundown settings for the acceptor using position D.
Switches between factory EEPROM sorting configurations and routing plug mode using position E.
Details the circuit for a standard cctalk serial interface implementation using open-collector transistor.
Describes a simplified, lower-cost direct diode interface circuit for cctalk communication.
Presents a direct microcontroller interface solution using a single pin for cctalk data line.
Explains how to connect a PC to the cctalk data bus using a Maxim level-shifter IC.
Provides step-by-step instructions for removing and re-installing the front-entry acceptor body.
Details procedures for cleaning the coin rundown area using a damp cloth only.
Instructions for detaching and refitting the accept gate mechanism, including spring handling.
Procedures for removing and re-installing the coin sorter unit, ensuring correct flap fitting.
Provides a graph illustrating the accepted range of coin diameters and thicknesses.
Outlines the operating and storage temperature and humidity ranges for the acceptor.
Provides detailed dimensional drawings for the top entry configuration of the SR5.
Provides detailed dimensional drawings for the front entry configuration of the SR5.
