Mongoose BMX - Attaching the Pedals

3 Assembly
32
WARNING!
Figure 3.31
❶ Match the pedal marked R with the right-hand crank arm
and match the pedal marked L with the le-hand crank arm.
Figure 3.31
❷ Place the threaded pedal into the threaded hole on the
crank arm.
❸ By hand, slowly turn the spindle the correct direcon.
Clockwise for right side pedal, counterclockwise for le side
pedal. Important! Stop if you feel resistance! This may be
an indicaon the spindle is entering the hole at an
angle. Remove the spindle and repeat step two and three.
❹ If the spindle is entering the hole cleanly then use a 15 mm
wrench or pliers to ghten completely.
❺ Repeat steps 1- 4 for the remaining pedal.
ATTACHTHEPEDALS
• Aachment of an incorrect pedal into a crank arm can strip
pedal threads and cause irreparable damage. Visually
match the R and L sckers on the pedal and crank arm
before aaching the pedals. Before your rst ride, please
check to ensure your pedals are aached correctly.
• It is very important that you check the crank set for correct
adjustment and ghtness before riding your bicycle.
The left pedal turns
counter-clockwise and
the right pedal turns
clockwise.
1
1
2
3
3