SIREN SOUNDS
A) Continuous - Door activation
B) Slow intermittent - Sensor triggered
C) Fast intermittent - Ignition triggered
D) ‘Whoop-whoop’ – Vehicle lights are on when arming
EMERGENCY OVERRIDE SWITCH - Ensure you know the location of this.
At the time of installation, a push button switch was hidden under the dashboard.
If the alarm fails to respond to the remote control, or you have misplaced it, you can override the alarm as follows;
1) Open the door with the ignition key - the siren will sound and the indicators will flash
2) Turn on the ignition
3) Press the override push button once - this will cancel the alarm sounding and override the system.
VALET MODE - LED PERMANENTLY LIT
To turn off the alarm system, turn the ignition on and press the override switch 3 times. LED will stay lit to
indicate valet mode. Repeat to turn the system back on. The remote will only operate the central locking whilst in
valet mode (if connected).
SECURITY RE-ARM (& RE-LOCK)
The alarm will automatically re-arm if it has been disarmed by remote but the doors have not been opened within
20 seconds. Doors also re-lock if central locking connected.
(This feature may not be operative if your vehicle has dome light supervision or is enabled by this
product)
IGNITION SAFETY DOOR LOCK - PROGRAMMABLE
If the system has been connected to a vehicle with central locking, the doors will lock 20 seconds after ignition
‘on’ and unlock with ignition ‘off’. If a door is left open during engine starting, the safety door lock feature will be
inoperative when the door is closed. 8
To Next Page
Loading...
