©2011
FINAL CHECK
Never inate a re beyond the maximum pressure marked on the re’s sidewall. Exceeding the recommended pressure
may blow the re o the rim, which could cause damage to the bicycle and injury to the rider and bystanders.
Tighten both front/rear wheel axle nuts or the quick release mechanism securely. Failure to do this may cause the
front/rear wheel to dislodge from the frame dropouts resulng in serious damage or injury.
• Aer all adjustments have been made, shi through every gear several mes at varying speeds. This will ensure all your adjustments
are correct and will allow you to pinpoint any trouble areas. If you encounter any problems, refer to the appropriate secon and make
any necessary adjustments.
• Check the re pressure and inate each tube to the recommended psi as stated on the sidewall of the re.
• Check that the kickstand operates smoothly and the kickstand bolt is secured ghtly.
• Finally, examine the bicycle. Make sure all accessories are aached and all quick releases, nuts and bolts have been ghtened securely.
• Correct maintenance of your bicycle will ensure many years of happy riding. Service your bicycle regularly by referring to the relevant
secons of this manual, OR take it to a professional bicycle shop. Remember: Always wear a helmet and obey all trac laws.
ASSEMBLY
47
To Next Page
Loading...
