Monitor Audio STUDIO 89 - Wiring Your Speakers

6 7
Wiring your speakers
Bare Wire Connection
Unscrew the binding posts and pass the bare wire through the hole in the binding post.
Tighten the binding post to clamp the wire in place.
Banana Plugs
Remove the small red and black terminal caps.
Insert the banana plugs into the standard 4mm holes in the centre of the terminal.
Spade Connectors
Unscrew the binding post and place the spade connector around the exposed thread.
Tighten the binding post to clamp the spade connector in place.
-
+
-
+
Bare Wire Connection Banana Plugs
RightIntergrated Amplifier
+
-
+
-
Left