– 47 –
Fire Alarm System (cont’d)
THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
Manually
Initiating
a Fire Alarm
1. Should you become aware of a fire emergency before your smoke or
heat detectors sense the problem, go to your nearest keypad and
manually initiate an alarm by pressing the panic key assigned for
FIRE emergency for 2 seconds (see below). If a key pair has been
assigned for fire, press both keys at the same time. See the Using
the Panic Keys section below for further details.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify
your local Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the
alarm. The zone number(s) of the zone(s) in an alarm condition will
be displayed at the keypad.
Using the
Panic Key(s)
Assigned for
FIRE
Emergency
A key or key pair may have been assigned for manually initiating a
FIRE alarm. See the Panic Keys section for key assignments.
For convenience, indicate the key or key pair assigned for fire below.
Individual Keys
A B C
Press the individual key assigned for fire for 2 seconds.
OR
Key Pairs
1
OFF
and
∗
READY
(zone 95)
∗
READY
and
#
(zone 99)
3
STAY
and
#
(zone 96)
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
FIRE 95
95
9595
95
ALARM
AC
ALPHA DISPLAY KEYPAD
FIXED-WORD KEYPAD
Press both keys of the
key pair assigned for
fire at the same time.
To Next Page
Loading...
Need help?
General