OVEN SETTINGS EXPLAINED - HIGH LEVEL
OVEN TYPE –
Set this to DX.
MAX. BAKE TEMPERATURE –
Can be set up to 300C , (depending on the oven type)
TEMPERATURE OFFSET –
Can be used to adjust the display to the actual temperature in the oven.
BAKE HYSTERISIS –
Sets bake temperature cycling around a set point. (Above and below).
BAKE CYCLE SET POINT ONLY –
No = Shows set temperature point and actual temperatures on screen.
YES = shows set temperature point only
MANUAL DEFAULT TEMPERATURE –
Set for manual program default temperature
SLEEP FALLBACK –
Temperature of the oven in “sleep mode” (100C is suggested).
SLEEP HYSTERISIS –
Sets “sleep mode” temperature cycling around a set point. (Above and below).
READY ACCEPT HIGH –
Highest temperature for the oven to display “READY”
READY ACCEPT LOW –
Lowest temperature for the oven to display “READY”
STEAM TYPE –
Plate or trough.
TOP GAIN –
0-255 centigrade
BOTTOM GAIN –
0-255 centigrade
MONO CONSTANT –
Factory set (Do not change unless instructed to do so)
STEAM TROUGH TEMP –
Degrees Centigrade
STEAM HYSTERISIS –
Degrees Centigrade
STEAM TROUGH EXCEPT –
Degrees Centigrade
To Next Page
Loading...
