Mono FG166-G11RH

MX Eco-touch Rotary Rack Gas Oven (FG166)
Rev. B21 21-05-21 MONO EQUIPMENT
16
4.0 SAFETY
1. This oven is designed for baking bread, confectionery and savoury bakery
products. Do not use it for other items without consulting with MONO.
2. This appliance is not intended for outdoor use.
3. This appliance is not intended for residential use.
4. It is essential for proper and safe operation of the oven that users are familiar with its
operation and use. Read the instructions provided in this document before use.
5.
EVERY OVEN INSTALLATION MUST BE APPROVED BY THE LOCAL AUTHORITY
Neither the manufacturer, nor the vendors are liable in respect of accidents or damage
where the purchaser/installer has not obtained such approval.
6. Connection of the oven to the local gas supply is the responsibility of the installer, who
should be a “Gas Safe” registered engineer using components that conform to the current
industry standards.
7. It is the responsibility of the installer to ensure that an adequate supply of combustion air to
the oven (see Specifications section for details) and the evacuation of combustion products
are permanently in place.
8. An emergency isolation valve must be fitted in the gas supply and be well marked and
accessible to operators.
9. No change is permitted to the gas group or family from that which is specified for this oven.
10. Parts of the oven that are protected by paint are not to be adjusted.
Do not adjust these parts.
11. Unauthorised service or repairs to these ovens may cause personal injury or damage to the
equipment, which may invalidate warrantee agreements.
12. Only qualified engineers appointed by MONO EQUIPMENT should carry out service and
repairs to this equipment.
13. Electrical panels and electrical distributor boxes should not be opened until the main
supply to the oven has been turned off.
14. When choosing and installing a flue, the precautions and instructions in this manual must
be observed.
In the interest of safety and efficient operation of the oven, it is essential that this manual
should be made available to the operator before work is commenced.
The following points should be observed and followed at all times.