18
Installation
$&&(6625,(6³72(.,&.(provided)
• Install the toekick after the range has been leveled.
• Measure the distance between the floor and the
bottom of range.
• Loosen the two screws on each end. Adjust the
toekick height by sliding the upper and lower pieces
apart to 1/8” less than the measured height.
• Secure the top and bottom sections by tightening
the 2 screws on each end.
• Push toekick against range leg until clip snaps
to legs.
NOTE: Be sure the toekick snaps securely to the leg.
Bottom
of Toekick
Screw
Push
Push
Top of
Toekick
To Next Page
Loading...
