Monogram Vent hood - Charcoal Filter Replacement

Careand Cleaning
Chimney Hood
Charcoal filter
(on some models)
If the model is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and odors.
Thecharcoal filter should be replaced when it is
noticeabl 9 dirty or discolored (usually after 6 to 12
months, depending on hood usage).
NOTE:DONOTrinse,or put charcoal filter in an
automatic dishwasher.
The charcoal filter cannot be cleaned. It must be
replaced.
Order Charcoal Filter WBO2X11342.
Toinquire about purchasing replacement charcoal
filters or to find the location of a dealer nearest _tou,
pleasecall our toll-free number:
National Parts Center 800.626.2002
To remove:
1. Remove the metal filter-see Metal grease filter
section.
2. Remove the charcoal filter in the same manner
as the metal grease filter bg pressing the filter
latch in to release it. Pull the filter down and out.
To replace:
1. Insert the black charcoal filter into the opening.
Push the latch on both sides toward the center
and engage the flange.
2. Replace the metal filter-see Metal grease filter
section.
Stainless
steel hood
surfaces
Regularlg polish the stainless steel exterior
with Stainless Steel Hagid" and the Honogram
polishing cloth, to preserve and protect the
fine finish.
To avoid scratching the fine finish of the
stainless steel, wipe in the same direction as the
grain when polishing or cleaning any stainless
steel surface.
For regular cleaning, use clean water and a soft
cloth, if stains persist, wash with mild dish soap
using a soft cloth or nonabrasive pad. For more
difficult stains, make a solution consisting of
25% vinegar (white or red) and 75% waten Dip
a soft cloth into the solution and rub onto the
stainless steel to remove the stain. If these
methods do not remove the stains, dirt or
debris, call 800.GECARES.
NOTE:Reapply StainlessSteel Hagic with the
Honogram polishing cloth after cleaning or if your
unit comes in contact with water, to protect the
fine finish.
StainlessSteel Hagic and the Honogram polishing
cloth are available through GEParts and
Accessories,800.626.2002 or monogram.com.
For StainlessSteel Hagic, order part number
WXIOX15.
Do not use appliance wax or polish on ang
stainless steel surface.
Do not use scouring pads, powdered cleaners,
bleach or cleaners containing bleach because
these products can scratch and damage
the finish.
Warrantg does not cover damage due to
improper cleaning methods.
Light bulbs
CAUTION: Allow bulbs to cool before
touching.
To change the light bulbs:
1. Pressand turn the light bulb face 1/4 turn.
2.The bulb will drop straight out.
& Replacewith the same size bulb bg placing bulb
prongs into the keghole slots and turning 1/4
turn to lock in place.
These 120 volt, 50 watt, MR16 halogen bulbs
with GU10 bases are available at most specialtg
lighting stores, building centers and large
retailers.Ask for MR16 GUIO base bulb.
NOTE:Do not replace with bulbs greater
than 120 volts, SOwatts, or the lights will
automatically shut off and the rings around the
operating buttons will flash to indicate the bulbs
have exceeded the acceptable limits.