Questions?
Use this
problem
solver!
The Problem Solver
Chimneg Hood
PROBLEM POSSIBLE CAUSE
FAN AUTOMATICALLY
TURNS ON OR INCREASES
IN SPEED AND CAN NOT
BE TURNED OFF OR
LOWERED IN SPEED
FAN DOES NOT
OPERATE WHEN
TURNED ON
The hood fan will turn on automatically or automatically increase in
speed if cooking temperatures become too hot. The fan will turn off
automatically or decrease in speed when temperatures cool to an
appropriate level. Fan will also turn on automatically when the hood
electronics are too hot.
NOTE: When the automatic fan feature is on, you can set the fan to
a higher setting but not to a lower setting or off.
A fuse may be blown or a circuit breaker tripped. Replace fuse or
reset circuit breaken
The power disconnect switch inside the hood may be switched of/
Remove the metal grease filter and the charcoal filter (if present} and
flip the switch on.
LOCATE ON/OFF SWITCH.
1. Press in to release and lower the filter cover panel at the front.
2. Pushthe filter latch toward the opening and pull downward
to remove.
3. Remove the charcoal filter, if present.
<.o
Presscorners
Filtel
latch
S. Press switch to ON position.
O
Push-bu_on
switch
(horizontal
view from
inside
opening)
NOTE:If the hood blower needs to be removed for service, use the
disconnect switch for your safety. Pressthe switch to the OFFposition.
4. Reach into the motor compartment and locate the ON/OFF switch
at the front of the opening.
To Next Page
Loading...