NOTES:
* If you are in a high humidity area and you see condensation on the chiller or the
water lines, the water temperature in the chiller must be raised.
Failure to do so may result in the Co2 tube shorting down!
* You must clean the air filter regularly to maintain proper air flow.
* Make sure there are no obstructions within one foot of the chiller for proper air
flow.
The T504 intelligent temperature controller is shipped from the factory in
intelligent mode (Mode 1) with a factory setting for the water temperature at 25
degrees Celsius (73.4F).
The T503 and T504 controllers have the same functions except the factory
parameter settings are slightly different.
LED Lights & Panel:
THE TOP LEFT LED:
LED ON: Set to intelligent mode
LED OFF: Set to user temperature control mode
FLASHING: Displaying the room temperature
To Next Page
