EN
9
BEFORE USING THE APPLIANCE
is level and stable. You can adjust the legs by turning them
in either direction. This should be done before placing food
in the fridge freezer.
• Before using your fridge freezer, wipe all parts with
a solution of warm water and a teaspoon of sodium
bicarbonate, then rinse with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes
at the rear) by turning it 90° (as shown in the gure) to
prevent the condenser from touching the wall.
• The fridge freezer should be placed against a wall with a
free space not exceeding 75 mm.
Electrical connection (For UK type plug)
For your safety please read the following information
Warning: This appliance must be earthed.
This appliance operates from 220-240 volts and should be
protected by a 13 amp fuse in the plug.
The appliance is supplied with a standard 13 amp 3-pin
mains plug tted with a 13-amp fuse. Should the fuse require
replacement, it must be replaced with a fuse rated at 13 amp
and approved to BS1362.
If the mains plug which is tted is unsuitable for the socket
outlet in your home or is removed for any other reason, please
follow the instructions below on how to wire a 13 amp 3 pin
plug..
How to wire a 13 amp plug.
Important
The wires in the mains lead on
this appliance are coloured in
accordance with the following
code:
Green and Yellow - Earth
Blue – Neutral
Brown – Live
As the colours may not correspond with the markings
GREEN/YELLOW
Earth
BROWN
Live
FUSE
13 Amps
Cord Clamp
BLUE
Neutral
To Next Page
Loading...
